Request an Assembly Quote

Please use this page to send details of your specific Girder Clamp application - your request will be handled as quickly as possible.

Please take the time to fill in all of the fields below - all are necessary to help us in providing you with a first rate service. (Required fields are in red)

Contact Information

(Note: include area/country code, like: 313-555-1212)

Urgent? Yes No

Beam Specifications

Please enter as much information as you have about your top and bottom steel sections. If you have the serial numbers then this is enough but if you do not have the numbers ideally we would need to know the width and flange thickness for each section.

end_S end_C end_truss end_W Unknown
end_S end_C end_truss end_W Unknown

Load Information

Please enter details of the load that each connection needs to support and any other conditions we need to be aware of when designing a solution for your requirement.

Additional Information

If the connection has anything specific we need to know about such as a specific angle of cross-over, a specific gap between the steel sections or a pitch angle when connecting to roof rafters then please specify the details below:

Is the connection similar to any catalogue illustration?

Do beams run vertically? Yes No

Is either beam at an inclined angle? Yes No

If yes, please attach the details, preferably a sketch/detail drawing.
You can attach a Word document, PDF, CAD Drawing, or GIF/JPG drawing using the following button.

Is there a height difference between the beams/steelwork ? Yes No